5-7/8 OD 3/16 Width 357 Viton O-Ring 5-1/2 ID Round 90A Durometer Pack of 2 Black

357 Viton O-Ring, 90A Durometer, Round, Black, 5-1/2' ID, 5-7/8' OD, 3/16' Width (Pack of 2): O Ring Seals: Industrial & Scientific. 357 Viton O-Ring, 90A Durometer, Round, Black, 5-1/2" ID, 5-7/8" OD, 3/16" Width (Pack of 2): O Ring Seals: Industrial & Scientific. Made of Viton (fluorocarbon elastomer) for use with a variety of chemicals and fuels 。 Durometer (hardness) of 90A for resistance to penetration 。 Round cross-section to provide a seal between cylindrical overlapping surfaces 。 For use across a wide temperature range from -15 degrees F/-26 degrees C to 400 degrees F/ 205 degrees C 。 Meets standards defined by Aerospace Standard AS568A 。 This O-ring is made of black Viton and has a durometer of 90A, a round cross-section, and can be used across a wide temperature range (-5 degrees F /-2 degrees C to 400 degrees F/ 205 degrees C). Designed for use in a wide variety of sealing applications, this Viton O-ring meets standards defined by Aerospace Standard AS58A, which is the Aerospace Size Standard for O-rings.。 Viton (fluorocarbon elastomer) has heat, fuel, and chemical resistance and is compatible for use with non-flammable hydraulic fuels, silicone oil, chlorinated hydrocarbons (trichlorethylene), fuels, aromatic hydrocarbons (benzene) and aliphatic hydrocarbons (propane), as well as high vacuum environments, ozone, and weathering. Viton is vulnerable to low molecular organic acids, ammonia gas, alkalis, amines, glycol-based brake fluids, and super-heated steam.。 The durometer hardness of this Viton O-ring is 90A. Durometers measure the hardness of a material and its resistance to permanent indentation. A higher durometer value indicates greater resistance to indentation. On a scale of 0 to 00, a value of 0 indicates that a sample was completely penetrated, while a value of 00 shows no indentation in the sample. The letter following the number identifies the shore scale, which is either shore A or D. Shore A is used for softer plastics, while shore D is used for harder plastics.。 O-rings provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section, and a hole in the center, similar to a doughnut. O-rings are available in various AS58A dash sizes, which is the standardized sizing for O-rings, and defines the nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter of an O-ring.。 。 。 。 。

5-7//8 OD 3//16 Width 357 Viton O-Ring 5-1//2 ID Round 90A Durometer Pack of 2 Black